Extracting Dry Materials; Extracting Wet Materials/Liquids - Festool CTL 26 E AC HD Manual De Instrucciones

Sistemas móviles de aspiración
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
Possible causes
Monitoring electronics malfunction.
Wet extraction.
7.6
Systainer depot
The surface of the mobile dust extractor doubles up
as a surface for storing Systainers:
Place the Systainer in the Systainer retainer [3a].
A Systainer adapter (accessory) must be attached
to the top section using four screws in order to
obtain a secure connection [3b].
8
Working
8.1
AUTOClean - Cleaning the main filter
Only in conjunction with disposal bag (com-
pliance with dust class 'L/M'). Not suitable for
wet extraction!
Automatic cleaning
Activate using the rotary knob [1-14].
Manual cleaning
Turn the switch [1-12] to the AC symbol.
Full manual cleaning [4]
Cover the end of the nozzle or suction hose with
your hand or closing slide CT-VS (497926).
Turn the switch [1-12] to the AC symbol.
8.2

Extracting dry materials

CAUTION
Hazardous dust
Damage to the respiratory passage
Always use a filter or disposal bag!
Only use when volumetric flow monitoring is
functional (dust class M only).
When extracting large quantities of oak or
beech wood dust or dust that exceeds the per-
mitted limit values, only extract from a single
machine (electric or air tool).
Observe the following when extracting dust generat-
ed by operating electric power tools:
Ensure there is adequate ventilation! Observe re-
gional regulations!
Limit values: exhaust air max. 50% of the clear air
volume
Formula: room volume V
x air renewal rate L
R
W
Solution
Send to a Festool service workshop for repair.
Functional reliability not affected, no actions required.
8.3

Extracting wet materials/liquids

Remove the filter or disposal bag!
Recommendation: use special wet filter (NF-
CT).
The dust extractor stops automatically when the
maximum level is reached.
After wet extraction, allow the main filter to dry!
Escaping foam and fluids
Switch off and empty the machine immediately.
8.4
After finishing work
Clean the main filter automatically or manually
(see Chapter 8.1).
Switch off the mobile dust extractor and pull out
the mains plug.
Wind up the mains power cable, secure the end of
the cable in the slot [5].
Empty the dirt trap.
Place the mobile dust extractor in a dry room in-
accessible to unauthorised users.
Fold up the hose holder [1-10].
Wind the hose around the bracket on the hose
holder.
Push the end of the hose over the bracket.
Dust class M only: close the intake opening [1-7]
with the sealing plug [1-1] or closing slide [1-
16].
Hazardous dust
Damage to the respiratory passage
Clean the mobile dust extractor and all accesso-
ries thoroughly using the extractor (inside and
out) and wipe down before removing from the
working area (dust class M only).
Parts that you were not able to clean thoroughly
must be sealed in an airtight plastic bag prior to
transportation.
Wear a dust mask.
CTL /M
CAUTION
WARNING
GB
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ctl 36 e ac hdCtm 36 e ac hdCleantex ctl 36 e ac hdCleantex ctm 36 e ac hd

Tabla de contenido