Sony DR-V150iP Manual De Instrucciones

Stereo
Headset
DR-V150iP
©2010 Sony Corporation Printed in Thailand




English
Stereo headset
WARNING
To reduce the risk of fire or electric shock, do not expose this apparatus to rain
or moisture.
To reduce the risk of electrical shock, do not open the cabinet. Refer servicing to
qualified personnel only.
You are cautioned that any changes or modifications not expressly approved in this
manual could void your authority to operate this equipment.
Features
 Easy-to-use remote control (only for iPod and iPhone).
 In-line microphone for hands-free phone calls of iPhone.
 Reversible earcup design for easy single-sided monitoring.
4-179-895-12(1)
Operating Instructions
Manual de instrucciones

How to use
Wearing the headphones

Wear the headphone marked on your right ear, and the one marked
How to use the remote and microphone for an iPod and
iPhone (see fig. )
You can control a connected iPod and iPhone product.
Parts and controls
 Volume +
Increases the volume of the connected iPod product.
 Center button
Plays/pauses a track of the connected iPod product with a single press. Skips to the next
track with a double press. Skips to the previous track with a triple press. Starts the
"VoiceOver*" feature with a long press (if available).
Press once to answer the call. Press again to end.
Hold down for about two seconds to reject an incoming call.
When you let go, two low beeps confirm the call was rejected.
 Volume –
Decreases the volume of the connected iPod product.
 Microphone
Compatible products
You can use the unit with only the following models supporting remote control.
 iPod nano 4th generation (video)
 iPod nano 5th generation (video camera)
 iPod classic 120GB 160GB (2009)
 iPod touch 2nd generation
 iPod shuffle 3rd generation
 iPhone 3GS
* Availability of the "VoiceOver" feature depends on iPod and its software version.
Specifications
Headphone
Type: Closed, dynamic
Driver unit: 30 mm, dome type (CCAW)
Power handling capacity: 500 mW (IEC*)
Impedance: 24 Ω at 1 kHz
Sensitivity: 98 dB/mW
Frequency response: 16 – 22,000 Hz
Cord: Approx. 1.2 m (47
plug
Plug: Four-conductor gold-plated stereo mini plug for iPod and
iPhone with remote function
Mass: Approx. 120 g (4
Microphone
Open circuit voltage level: – 42 dB ( 0 dB=1 V/Pa)
Supplied accessories
Card warranty (1)
Operating Instructions (1)
* IEC = International Electrotechnical Commission
Design and specifications are subject to change without notice.
Precautions
 Listening with headphones at high volume may affect your hearing. For traffic safety,
do not use while driving or cycling.
 Do not subject the headphones to excessive shock.
 Handle the driver units carefully.
 Do not put weight or pressure on the headphones as it may cause the headphones to
deform during long storage.
 The earpads may deteriorate due to long-term storage or use.
 Do not leave the jack plug dirty otherwise the sound may be distorted.
 Clean the headphones with a soft dry cloth. Do not blow on the units when cleaning.
Do not allow the plug to become dirty, otherwise the sound may deteriorate.
 Do not leave the stereo headphones in a location subject to direct sunlight, heat or
moisture.
On copyright
iPod and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries.

on your left ear.
/ in) long cord with stereo unimatch
1
2
/ oz) without cord
1
4