Installing Batteries In The Remote Control; Connections; Connecting Vhf And Uhf Antennas - Samsung LN-S4095D Instrucciones Del Propietario

Ocultar thumbs Ver también para LN-S4095D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installing Batteries in the Remote Control

Connections

Connecting VHF and UHF Antennas

Antennas with 300 Ω Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300 Ω twin flat leads, follow the directions below.
ANT 2 IN
(CABLE)
Antennas with 75 Ω Round Leads
ANT 1 IN
(AIR)
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before connecting
the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronics shops).
UHF
VHF
ANT 1 IN
(AIR)
UHF
VHF
1. Lift the cover at the back of the remote control upward as shown in the figure.
2. Install two AAA size batteries.
Make sure to match the "+" and "–" ends of the batteries with the diagram inside the
compartment.
3. Replace the cover.
Remove the batteries and store them in a cool, dry place if you won't be using the remote
control for a long time.
The remote control can be used up to about 23 feet from the TV.
(Assuming typical TV usage, the batteries last for about one year.)
If the remote control doesn't work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
If your antenna has a set of leads that look like this, see "Antennas with 300 Ω Flat Twin Leads"
below.
If your antenna has one lead that looks like this, see "Antennas with 75 Ω Round Leads".
If you have two antennas, see "Separate VHF and UHF Antennas".
1. Place the wires from the twin leads under the screws on a 300-75 Ω adapter
(not supplied).
Use a screwdriver to tighten the screws.
2. Plug the adaptor into the ANT 2 IN (CABLE) terminal on the back of the TV.
1. Plug the antenna lead into the ANT 1 IN (AIR) terminal on the back of the TV.
1. Connect both antenna leads to the combiner.
2. Plug the combiner into the ANT 1 IN (AIR) terminal on the bottom of the rear panel.
English-8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ln-s4695Ln-s4695d

Tabla de contenido