Troubleshooting - Yamaha PDX-W61 Manual De Instrucciones

Status Indicators (LEDs)
Indicate the status of the speaker unit, the transmitter, and a connected iPhone/iPod. The status of a connected external device is
not indicated.
• Green status indicator: The speaker unit and transmitter are turned on and operating normally.
• Red status indicator: An error has occurred or the volume has reached its maximum or minimum level.
Speaker unit Transmitter
Green Red Green
Once Once
Once
Once Once
2 sec.
...Lit ...Flashing
Refer to the table below if the speaker unit or transmitter does not operate properly. If the problem you are experiencing is
not listed below, or if the instruction below does not help, disconnect the power cable plug, and contact the nearest authorized
Yamaha dealer or service center.
For problems related to wireless connections, please provide information about other wireless devices that you are using
(manufacturer, model number, etc.).
Problem
No sound.
Red
An iPhone/iPod is connected.
The volume level has been adjusted.
The transmitter's status indicator flashes only when the volume was adjusted using the
speaker unit's volume keys.
Connection in progress, please wait.
30 seconds have passed since the iPhone/iPod was paused.
The speaker unit's volume has reached the maximum or minimum level when an
iPhone/iPod is connected wirelessly.
The transmitter's status indicator flashes only when the volume was adjusted using the
Once
speaker unit's volume keys.
The speaker unit's volume has reached the maximum or minimum level when an
external device is connected to AUX.
The battery of the iPhone/iPod is low. Charge the iPhone/iPod.
The connected iPod is not supported.
Refer to "SPECIFICATIONS" for the supported iPods.
2 sec.
Connection failed.
Refer to "TROUBLESHOOTING" for the proper remedy.
An error occurred in the speaker unit.
Refer to "TROUBLESHOOTING" for the proper remedy.
An error occurred in the transmitter.
Refer to "TROUBLESHOOTING" for the proper remedy.
...Off ...The previous condition continues

TROUBLESHOOTING

Cause
The volume is turned down.
The iPhone/iPod is not connected
securely.
The external device is not connected
securely.
Earphones are connected to the iPhone.
CONTROLS AND OPERATIONS
Status
Remedy
Turn up the volume.
Connect the iPhone/iPod securely.
Connect the 3.5 mm (1/8 in) stereo mini
plug cable securely to the speaker unit
and external device.
Remove the earphones.
4
En