Lcd Screen - TFA Dostmann 30.3012 Manual De Instrucciones

3. Remove the battery cover at the front side.
4. Checking the correct polarization, insert 2 x AAA, IEC LR3, 1.5V batteries into the battery
compartment and replace the cover.
5. If you have purchased additional outdoor transmitter(s) wait until the outdoor temperature has
been received from the one transmitter before activating the next transmitter by repeating
steps 3 and 4.
6. However, ensure that you leave 10 seconds in between the reception of the last transmitter
and the set-up of the following transmitter. The Remote Thermo will number the transmitters
in the order of set-up, i.e. the first transmitter will have the temperature displayed with the
number 1 against it and so on.
7. When the outdoor temperature(s) is received the Remote Thermo and transmitter(s) should
be positioned in the desired places (see Positioning & securing below)
Note:
Should the total time of inserting the batteries into the transmitters take longer than 2-1/2 minutes
from the time of inserting the batteries into the Remote Thermo then temperature reception
problems may occur. If the temperature is not be received, then see Checking for 433 MHz
reception, before resetting the units (see Resetting the Remote Thermo below).
In the event of changing batteries in any of the units, all units need to be reset by following the
setting up procedures. This is because a random security code is assigned by the transmitter at
start-up and this code must be received and stored by the Remote Thermo in the first 2-1/2 minutes
of power being supplied to it.

LCD SCREEN

The Remote Thermo's LCD is comprised of three lines and once the batteries are inserted, all the
segments will light up momentarily before displaying:
1. Time "-:--"
2. Indoor temperature in degree Celsius (°C)
3. Outdoor temperature in degree Celsius (°C)