of moving parts, breakage of parts, mountings, air
leak and any other conditions that may affect its ope-
ration. A guard or other part that is damaged should
be properly repaired or replaced by an authorized ser-
vice center unless otherwise indicated elsewhere in
this Instruction Manual. Defective pressure switches
should be replaced by authorized service center. Do
not use compressor if power switch does not turn it
on and off.
16. OPERATE THE COMPRESSOR ACCORDING
TO THE INSTRUCTIONS PROVIDED HEREIN
This compressor has been designed and ma-
nufactured exclusively to produce compressed air.
Operate the compressor according to the instructions
provided herein.
17. HANDLE COMPRESSOR CORRECTLY
Operate the compressor according to the in-
structions provided herein. Never allow the compres-
sor to be operated by children, individuals unfamiliar
with its operation or unauthorized personnel.
18. KEEP ALL SCREWS, BOLTS AND COVERS
TIGHTLY IN PLACE
Keep all screws, bolts, and plates tightly mounted.
Check their condtions periodically.
19. KEEP MOTOR AIR VENT CLEAN
The motor air vent must be kept clean so that air
can flow freely at all times. Frequently check for dust
build-up.
20. OPERATE COMPRESSOR AT THE RATED
VOLTAGE
Operate the compressor at voltages specified on
their nameplates. If using the compressor at a higher
voltage than the rated voltage, it will result in abnor-
mally fast motor revolution and may damage the unit
and burn out the motor.
21. NEVER USE A COMPRESSOR WHICH IS DE-
FECTIVE OR OPERATING ABNORMALLY
If the compressor appears to be operating unu-
sually, making strange noises, or otherwise appears
defective, stop using it immediately and arrange for
repairs by an authorized service center.
22. DO NOT WIPE PLASTIC PARTS WITH SOL-
VENT
Solvents such as gasoline, thinner, benzene, car-
bon tetrachloride, and alcohol may damage and crack
plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened
with soapy water and dry thoroughly.
23. USE ONLY GENUINE REPLACEMENT PARTS
Replacement parts which are not original may void
your warranty and can lead to malfunction and resul-
ting injuries. Genuine parts are available from your
dealer.
24. DO NOT MODIFY THE COMPRESSOR
Do not modify the compressor. Always contact the
authorized service center for any repairs. Unauthori-
zed modification may not only impair the compressor
performance but may also result in
accident or injury to repair personnel who do not
have the required knowledge and technical expertise
to perform the repair operations correctly.
25. TURN OFF THE PRESSURE SWITCH WHEN
THE COMPRESSOR IS NOT IN USE
When the compressor is not used, turn the knob
of the pressure switch OFF, disconnect it from the
power source and open the drain cock to discharge
the compressed air from the air tank.
26. NEVER TOUCH HOT SURFACES
To reduce the risk of burns, do not touch tubes,
heads, motors and cylinder.
27. DO NOT DIRECT AIR STREAM AT BODY
Risk of injury, do not direct air stream at persons
or animals.
28. DRAIN TANK
Drain tank daily or after 4 hours of use. Open drain
fitting and tilt compressor to empty accumulated wa-
ter.
29. DO NOT STOP COMPRESSOR BY PULLING
OUT THE PLUG
Use the "AUTO/OFF" knob of pressure switch.
30. USE ONLY RECOMMENDED AIR HANDLING
PARTS ACCEPTABLE FOR PRESSURE NOT LESS
THAN 125 PSI (8.6 BAR)
Risk of bursting. Use only recommended air han-
dling parts acceptable for pressures not less than 125
psi (8.6 bar).
INTENDED USE
This compressor has been designed for DIY use
with intermittent (not continuous) operation. The use
of the compressor for more than 25min. during one
hour is not recommended.
14