Makita 9820-2 Manual De Instrucciones página 5

1
3
4
1mm
(3/64")
2
007271
Wiping off the antirust
Wipe off the antirust on the sharpening platform guide
(rail) and the sharpening holder. Coat the sharpening
platform guide and the sharpening holder with machine
oil or spindle oil.
Removing or installing sharpening platform
guide
To remove the sharpening platform guide, loosen the
screw and slip the set plate aside.
1
2
007272
Loosen the pole fastening screws counterclockwise and
lift off the sharpening platform guide.
1
2
3
007273
To install the sharpening platform guide, follow the
removal procedure in reverse.
Adjusting sharpening platform guide
In using the sharpening platform guide to sharpen
blade/knife, adjust the angle adjustment screw to the
desired blade/knife sharpening angle. The bevel
becomes acute as the angle adjustment screw is turned
clockwise.
1. Grinding wheel
2. Wheel guard
3. Lower
4. Raise
1. Slip aside
2. Set plate
1. Sharpening
platform guide
(Rail)
2. Pole
3. Pole fastening
screw
5
3
007274
The platform poles are fixed in place by tightening the
pole fastening screws clockwise.
1
007275
The nut for raising or lowering the pole on either side raises the
pole 0.5 mm (1/32") for each graduation, when turned
clockwise, and it lowers the pole, conversely, 0.5 mm (1/32")
when turned counterclockwise.
1
0.5mm
2
(1/32")
007276
Tilt the sharpening platform guide slightly with right side
downward so that the blade contacts the right side
surface of the grinding wheel.
1
007277
1. Sharpening
1
platform guide
(Rail)
2
2. Blade/knife
sharpening
angle
3. Angle
adjustment
screw
1. Pole
2. Pole fastening
screw
2
1. Raising
2. Lowering
3. Graduation
3
1. Sharpen here
2
2. Tilt slightly
downward
3. Sharpening
guide vertical
adjustment nut
3
4. Pole fastening
4
screw