Intended Use; Description Of The Components; Initial Operation; Using The Device - Clatronic MWG 769 H Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
If the machine is not clean the surface may be damaged,
affecting its serviceable life and possibly resulting in
hazardous situations.
Symbols on the device!
WARNING: Hot surface!
While the device is in operation the temperature of the expo-
sed surfaces may be very high.

Description of the Components

Description of Parts
1 Ventilation slits
2 Control panel with display
3 Cover
4 Sliding ring
5 Grilling grid
6 Drive axle
7 Door lock
8 Viewing window
9 Rotating plate
The buttons of the control panel
MicroPower
Grill.Combi
Conv.Combi
AutoCooking
PresetClock
AutoDefrost
Time.Weight
Stop.Cancel
Instant.Start
74
05-MWG 769 H_Unique.indd 74
05-MWG 769 H_Unique.indd 74
Power:
For selecting the power levels of the
microwave
Hot Air/Combi Grill/Combi
Hot Air:
Exclusive hot air operation, thermostat-
controlled
Hot Air/Combi:
Hot air and microwave work alternately
Grill:
For grilling and scolloping
Grill/Combi:
Grill and microwave work alternately
Cooking Programmes:
Selection of an automatic programme
by repeated pressing
Clock:
For setting the time together with the
arrow keys
Arrow Keys
For setting the time,temperatures or
weights
Stop/Clear
Press once to stop the cooking process
Press twice to delete the programme
Hold down for 3 seconds to lock/unlock
the device
Start of the Programme

Intended Use

This device is used:
for heating up and cooking solid or liquid foods,
for browning and grilling solid foods.
It is intended exclusively for this purpose and may only be
used as such. It may only be used in the manner described
in these instructions for use. The device must not be used for
commercial purposes.
Any other use of this device is considered to be contrary to the
intended use and may result in damage to materials or even
personal injury.
The fi rm Clatronic International GmbH does not accept any
liability for damage caused as a result of the use of this device
contrary to its intended use.

Initial Operation

If there are any oil or other residues from the manufacturing
process on the housing or heating element, smoke or
odours may initially be produced. This is normal and will not
occur after the oven has been used a few times.
The following procedure is strongly recommended:
Turn the oven to the hot air or grill function and operate it se-
veral times without any food inside. Please ensure adequate
ventilation.
CAUTION:
The oven can only be used without food inside with the
hot air or grill function; this is not possible during com-
bined or microwave operation!
After removing all the accessories from inside the oven, un-
pack them and place the sliding ring in the middle. Position
the glass plate on the drive axle in such a way that it locks
into the dents of the drive shafts and is lying fl at.
Check the device for any visible damage, particularly in the
area of the door. If any damage is found, the machine must
not be used.
In order to avoid interference to other machines when the
microwave oven is operated, do not place it in the direct
vicinity of other electronic devices.
Remove any protective foils that may be adhered to the
housing.
Insert the mains plug into a properly installed 230 V, 50 Hz
power socket.

Using the Device

What you should know about microwave operation:
Your device works with microwave radiation, which heats up
water particles in food in a very short time. There is no heat
radiation and therefore hardly any browning.
Only food should be heated up with this device.
Do not fry food in the microwave as hot oil may damage the
oven and lead to skin burns.
Only 1-2 portions should be heated up at the same time.
Otherwise the microwave will become less effi cient.
27.03.2008 10:51:54 Uhr
27.03.2008 10:51:54 Uhr

Publicidad

Tabla de contenido
loading

Tabla de contenido