Information Codes - Samsung VRT PLUS WF520AB Manual De Instrucciones, Uso Y Mantenimiento

INFORMATION CODES

Information codes may be displayed to help you better understand what is occurring with your washer.
ERROR IMAGE
Unbalanced load
The Door was unlocked wh-
ile the washer was running.
Door is open.
The Washer door would not
lock.
Water Temperature Control
Problem
Water Level Sensor Problem
Water Leakage Problem
The Door will not unlock.
No Draining
Low Water Pressure
WF520AB-02838A_EN.indd 35
MEANING
Unbalanced load prevented your
washer from spinning.
Door is unlocked when washer is
running.
Door is open when washer is running.
Your washer failed to lock the door.
Water temperature control problem.
(Heater control problem)
Water level sensor problem
Your washer has tried to fill but has not
reached the proper water level.
The door will not unlock.
Your washer is not draining.
It can also mean that the unit senses a
small clog while draining.
Your washer has tried to fill but was
unsuccessful.
Check if the hot water supply hose is
connected.
SOLUTION
Redistribute the load, press the Start/
Pause button.
Press the Power button to turn off your
washer, then restart the cycle. If the
code reappears, call for service.
Close the door tightly and restart the
cycle.
If the code reappears, call for service.
Close the door tightly and restart the
cycle.
If the code reappears, call for service.
Call for service.
Call for service
Call for service.
Make sure the door is firmly closed.
Press the Power button to turn off
your washer, then turn it on again. If the
code reappears, call for service.
Before calling for service, check the
following.Clean the filter (See page 31).
or
1. Turn off the unit for 10 seconds and
then turn it on again.
2. Select the Spin Only cycle.
3. Press the Start/Pause to drain the
water.
If it still does not drain, call for service.
Make sure the water faucets are open
all the way. Check for kinked hoses.
Check the inlet screens on the fill
hoses.
You must connect the hot water supply
hose because hot water is supplied by
the Auto Temperature Control (A.T.C.)
function if the temperature of the cold
water is lower than 59°F.
troubleshooting _35
2010-03-24 ¿ÀÈÄ 4:30:37