Restoring The Original Configuration - SOMFY SLIM IO RECEIVER RS+PLUG Manual

EN
Observations
I can't delete the Your control point is too old (Index E
"my" position with or older).
my Easy Sun io
control point.
I don't think the The linear travel setting is incorrect.
position between
The motor is close to the thermal
the end limits is
limit.
accurate.

6.2. RESTORING THE ORIGINAL CONFIGURATION

Attention
Only switch off power (double cutout) for the motorised product to be reset.
This reset deletes all programmed control points, sensors, linear travel and resets the
motorised product's favourite (my) position.
1) Position the motorised product at its half-way position.
2) Cut the power supply for 2 seconds.
3) Switch the power supply back on for 5 to 15 seconds.
4) Cut the power supply for 2 seconds.
5) Switch the power supply back on.
The motorised product moves for a few seconds.
28
Possible causes
Copyright © 2017 SOMFY ACTIVITE SA, Société Anonyme.. All rights reserved.
Slim io Receiver RS + Plug
Solutions
Delete the "my" position with
another paired control point.
Reset the linear travel.
Wait until the motor cools down.
OFF
ON
OFF
ON
2 s
5 s
15 s
2 s