MIRKA AROS-B 150NV Instrucciones De Manejo página 185

Proper use of tool
This sander is designed for sanding all types of materials such as paints, metals, wood, stone, plastics, etc , using
abrasives specially designed for this purpose Do not use this sander for any other purpose than that specified without
consulting the manufacturer or the manufacturer's authorized supplier Do not use backing pads with an operating
speed of less than 8,000 rpm free speed Any maintenance or repair work requiring the motor housing to be opened
may only be carried out by an authorized service center
Battery and charger
• The battery pack is not fully charged out of the carton First read the safety instructions and then charge your battery
according to the instructions
• For optimal charging capacity the battery should be charged at an ambient temperature between 18 °C (64 °F) and
24 °C (75 °F) To prevent damage to the battery pack, do not charge the battery pack where the air temperature is
below 4 °C (32 °F) or above 40 °C (104 °F)
• To obtain the longest possible battery life, we suggest the following:
– Store and charge your battery in a cool area Temperatures above or below normal room temperature will shorten
battery life
– Never store the battery in a discharged condition Recharge it immediately after it has been discharged
• All batteries gradually lose their charge The higher the temperature, the quicker they lose their charge
If you store your tool for long periods of time without use, recharge the battery every month This practice will prolong
battery life
Charging procedure
• Connect the power cord to the charger, and then plug into an outlet before inserting battery pack All three charging
lights will be on for two seconds and then turn off
• Insert the battery pack into the charger
• During the charging process, the charging lights will indicate the status as follows:
– Three charging lights will flash in sequence during the charging process
– Fully charged, all three lights will remain on continuously
• The charging process will last approximately 40 minutes for Mirka 10 8 V 2 0 Ah battery pack
NOTE: This charger can only charge Mirka 10 8 V battery packs
NOTE: Charging times may be longer depending on the surrounding temperature and battery conditions
LED indication of 10.8 V charger
LED
3
2
1
Pre-charge
(Trickle charge)
Remain continuously on
Flashing
Charging... Charging... Charging finished Over temperature
Mirka® AROS-B 150NV & AOS-B 130NV • 32 mm (1 ¼") • 10.8 V
en | us • ca
Battery failure
185