Mustang Fender GT40 Manual Instrucciones De Uso página 18

In the second method of adding an effect, highlight an existing effect in the SIGNAL PATH LAYER and press
the ENCODER. Select "ADD FX" from the menu of effects placement options and press the ENCODER again.
Select one the four effects categories that will appear and press the ENCODER to access the effects in that
category. Scroll through the effects and press the ENCODER to select an effect.
The SIGNAL PATH LAYER will then display the newly added effect in a green box with a blinking white arrow
below it and a label above it, indicating that the effect can be moved to a different position (if preferred) by
turning and then pressing the ENCODER.
When an effect is added, the box containing the preset number will change from blue to red (indicating that a
preset edit has been made), and the SAVE utility button will illuminate. With the effect now added, further ed-
its can then be made or the SAVE utility button can be pressed to keep completed edits (see illustrations below
and on next page).
In another way to add an effect, highlight an existing effect within a preset by turning the
ENCODER to it and pressing the ENCODER to see a menu of four effects categories.
Select "ADD FX" in the effects placement options menu by scrolling to it and pressing the ENCODER.
ROCK & ROLL
POST FX 1
TWIN
REVERB
FUZZ
REVERB
LEVEL DECAY DWELL DIFF TONE
BYPASS
REPLACE
MOVE
ADD FX
DELETE
STOMPBOX
MODULATION
DELAY
REVERB
Select an effects category by scrolling to it and pressing the ENCODER.
SIMPLE COMP
back
COMPRESSOR
WAH
TOUCH WAH
RANGER BOOST
Select an effect by scrolling to it and pressing the ENCODER.
16