GE 18 Manual Del Propietario E Instalación página 13

ge.com
Preparing for Vacation
For lollg x_lC;l[iOllS or nbsen(es, I'eIllO\P
fl>od and unplug the refiigerato_: Move
tile refligerator control to tile 0 (Off)position
and clean the interior with a baking soda
solution of one tablespoon (15 ml) of
baldng soda to one quart (l liter) of watel;
Leave the doo,_ open.
Set the icemaker power
switch to the 0 (off)
position or move the teeler man to the STOP
(up) position (depending on model) and
shut off tile water supply to tile refligerator.
If tile temperature
can drop below fl'eezing,
have a qualified sela'icer drain the water
supply s)_stem (on some models) to pre\'ent
serious prope_W)' damage due to flooding.
Preparing to Move
Secure all loose items such as grille,
shelves and drawers by taping them
securely ix*})lace to pre\ ent damage.
Besuretherefn_lerator stays/))anup@t posit/on
&n)_gmov/?)g
Replacing the light bulbs.
Setting either or both controls to 0 (off) does not remove power to the light circuit.
Some models have only one light.
Refrigerator Compartment--Upper Light
Lll_l_llt,llB._a_T_n_t'Llghtbu/bsmaybeho£ 0 Replace with an al)l)liance bulb of
tile salne or lower wattage
Unplug tile reh'igerator. 0 Plug tile refligerator back in.
0 Tile bulbs are located at tile top of tile
con_l)artment near tile oi)elfing.
Freezer Compartment Dome Light (on some models)
aUTION: L,Vh, bulbsbe @ dtei-repla
cing with a n applia nee
bulb
of tile same or lower wattage, replace
Unl)lug tile reflJgeratoi: tile shield.
0 The bulb is located behind a light _ Plug the refrigerator back in.
shield at the back of the ti'eezer
coii/l)artlilent. To i'eii/ove_
squeeze
tile top and bottoln of tile shield and
pull the shield off.
73