Reversing The Door Swing - GE 18 Manual Del Propietario E Instalación

Installation Instructions
[] PLUG IN THE REFRIGERATOR
&_rranoe the coil ot tubing so that it does not _ibrate
against the back of the refl'igerator or against the
wall. Push the refl'igerator back to the wall.
START THE ICEMAKER
On power switch models, set the icemaker power
switch to the I (On) position. On feeler arm models,
move the feeler
arm to the ON (down)
position. The
icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°(',) or below.
It will then begin operation automatically:
Powerswitchmodel
in
the ON(down)position
Feelerarmmodel
NOTE: In lower water pressure conditions, tile
water xalxe may turn on up to 3 times to delixer
eno//(rh water to tile icemaker.
REVERSING THE DOOR SWING
IMPORTANT NOTES
When reversing tile door swing:
• Read tile instluctions all tile way through befi)re
starting.
• Handle parts careflfllv to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching work surtace fin.
tile dooi_.
IMPORTANT: Once wm begin, do not move tile
cabinet until dooi=swing reversal is completed.
These instructions are fin" changing the hinges fl'om
the right side to the lett side--if w)u ever want to change
the hinges back to the right side, tollow these same
instructions and revei_e all references to lett and right.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment,
TOOLS YOU WILL NEED
Phillipsscrewdriver
Maskingtape
3/8" Head socket driver
(a 6-point socket is
recommended)
Puttyknife or
thin-bladescrewdriver
T2Oor T25Torx ®
driver,whicheveryour
modelrequires
19