Dometic CK40D Hybrid Instrucciones De Uso página 10

Operation
6.2 Using the coolbox
A
NOTICE! Risk of damage
• Do not switch on the device immediately after transporting it. This
could damage the cooling system. Leave the device to stand for
about 30 minutes after transporting, before you switch it on. This
allows the refrigerant to collect again in the compressor, and the
compressor does not run dry.
• Only operate the device from a single energy source. Simultaneous
use of the thermoelectric cooling system and the compressor is not
permitted.
• Ensure that the objects or goods placed in the cooling device are
suitable for cooling to the selected temperature.
• Ensure that food or liquids in glass containers are not excessively
refrigerated. Liquids expand when they freeze and can therefore
destroy glass containers.
• Ensure that your cooler is well ventilated so that any heat created can
dissipate. Otherwise proper functioning cannot be ensured. It is
especially important not to cover the air vents.
➤ Place the coolbox on a firm base.
Connection cable plug
12 V
Connecting the cooler to 12 V (thermoelectric mode)
I
NOTE
In thermoelectric mode, the thermostat has no function and the device
cannot deep freeze.
➤ Make sure the cable between the cooler and the battery is protected by a fuse
(maximum 5 A).
➤ Plug the 12 V connection cable (see figure) into the cigarette lighter socket or a
12 V socket in the vehicle.
✓ The cooler starts cooling the interior.
10
230 V
CK40D Hybrid
EN