Inserting Paper - Mettler Toledo P25 Manual De Usuario

Note
RS232 interface only: the pilot lamp will flash until an instrument is connected. If the lamp is still flashing check
the chapter "Troubleshooting" in the Reference Manual.

2.3 Inserting paper

1 Remove paper cover (pull on the back) (1).
2 Insert the paper rotary axis through the core of the paper
roll (2).
3 Feed paper through the slot in the printing unit in the
direction of the arrow (3).
4 Press and hold until enough paper has been fed (4).
5 Lead paper through the paper cover slot.
6 Place the paper cover (1) on.
If, after the first printouts the connection settings (Bauderate,
Bit, Handshake) of the balance change, the printer must be
restarted. Switch off / on to start the auto bauderate detection
again. Auto bauderate can be switched off.
6
3
4
2
1
Printer