Publicidad
Idiomas disponibles
Idiomas disponibles
Features
Top Panel
17
56
16
18
55
19
18
33
45
34
31
32
32
24
36
40
42
41
43
43
1. Input Selector: Set this switch to the desired audio source from this channel: USB (a track
playing on that layer in the software), Line (a device connected to the line input on the rear
panel), or Line/Phono (a device connected to the line/phono input on the rear panel).
Please note that the Line/Phono selector switches on the rear panel must also be set
properly. Also, a channel's controls will only send MIDI information when its input selector
is set to USB.
2. USB Selector: Press this button to select whether the deck is controlling the computer
connected to USB Port 1 or USB Port 2. Remember to set the channel's input selector
to USB if you want it to play the audio from that layer in the software.
3. Channel Level: Turn this knob to adjust the level of the pre-fader, pre-EQ audio signal for
the channel.
4. Channel Level Meters: These LEDs display the audio signal level of the channel.
5. Channel EQ: Turn these knobs to boost or cut the high, mid-range, and low frequencies
for the channel.
6. Channel Filter: Turn this knob to adjust the filter applied to the channel. Turn the knob
counterclockwise to apply a low-pass filter. Turn the knob clockwise to apply a high-pass
filter.
7. Channel Cue: Press this button to send the channel's pre-fader signal to the headphones'
cue channel.
57
56
56
11
55
55
58
54
29
28
37
38
39
35
2
50
1
1
3
48
4
4
51
5
52
5
53
49
5
23
6
7
7
30
9
44
46
47
8
25
26
27
14
1
3
3
4
13
5
5
5
5
15
5
5
21
6
6
20
7
22
9
9
12
8
8
10
2
1
3
4
5
5
5
6
7
9
8
5
Publicidad
