Storing The Pressure Washer - Homelite UT80715 Manual Del Operador

CLEANING THE DECK NOZZLES
See Figure 14.
There are two deck nozzles located under the cleaning
deck. If these nozzle become clogged, it may be necessary
to clean them.
To clean nozzles:
 Unplug the pressure washer.
 Turn off the pressure washer and shut off the water
supply. Pull the trigger to release water pressure.
 Tilt the cleaning deck backwards to expose the spray
bar.
 With a wrench, remove the holders from each end of the
spray bar then lift the nozzle from the holder.
 Using a straightened paper clip or nozzle cleaning tool
(not provided), free any foreign materials clogging or
restricting the nozzle.
 Using a garden hose, flush debris out of nozzle by back
flushing (running the water through the nozzle backwards
or from the outside to the inside).
 Slide the nozzle back into the holder.
 Place the holder and the spray bar and retighten.
MAINTENANCE
CHANGING THE HIGH PRESSURE FILTER
See Figure 15.
Once you have cleaned the deck nozzles, if the water still
doesn't flow freely from the spray bar, it may be necessary
to replace the high pressure filter.
To replace the filter:
 Unplug the pressure washer.
 Place a flathead screwdriver in the cleaning deck inlet
plug. The slot in the top of the filter will cause it to turn
so it can be lifted out of the machine.
 Once the filter is removed from the inlet plug, replace it
with a new filter (not included).
 Using a flat head screwdriver, turn the filter until it can no
longer be seen over the top of the inlet plug.

STORING THE PRESSURE WASHER

Allow 30 minutes of "cool down" time before storing the
machine. Store in a dry, covered area where the weather
can't damage it.
It is important to store this product in a frost-free area. Always
empty water from all hoses, the pump, and the detergent
container before storing.
NOTE: Use of a pump saver will give you better perfor-
mance and increase the life of the machine.
12 — English