Setting Up Power Supply; Automatic Measurement Display - Bresser 7007410CM3000 Manual De Instrucciones

7
9
11 MAX symbol (will be
13 Temperature unit (°C or

5 Setting up power supply

1.
2.
3.
4.
5.

6 Automatic measurement display

Measurements for the indoor area will be displayed on the
device once power supply was enabled.
Read the detailed manual for more information about read-
ings (see download information on page 2).
8 / 52
Humidity value (in %)
(display mode select-
able)
MIN symbol (will be dis-
played when lowest
value is reached)
displayed when highest
value is reached)
°F selectable)
Remove the stand clip.
Remove the battery compartment cover.
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
Replace the battery compartment cover.
Re-attach the stand clip.
8 Dew point symbol (will
be displayed when dew
point level is reached)
10 ALERT symbol (will be
displayed on alarm set-
ting)
12 Temperature value (dis-
play mode selectable)
14 Indoor climate indicator