Test Program; Mode Setting - König Electronic DL-QUAKE250 Manual De Uso

OPERATION:
Read "IMPORTANT INFORMATION BEFORE USE" first and verify all precautions are fulfilled before
operating.
Make sure the correct lamp is installed, read "SERVICE" how to (re)place the lamp.
Although the QUAKE250 cannot be dimmed, it may be switched on and off remotely using switch
packs or the full-on and full-off levels on dimmer packs. Disconnect the fixture from AC power when
not in use.
The QUAKE250 has an advanced control panel. To set the desired function please read the following
instructions carefully.
DMX address setting:
1. Press Menu button to access address code setting menu Axxxx
2. Press UP or DOWN button to set the DMX address code.
3. Press ENTER button to save the update DMX address code.
Address code setting range A001-A512

Test program:

Press Menu button to access the test program, select the menu TEST and press ENTER button to
save the setting, the LCD display flashes.
Press Menu button to exit this scene.

Mode setting:

Press Menu button to acces the menu Mode and press ENTER button to save the setting.
Press UP or DOWN button to select the mode of Auto or Sond or dMH.
Press ENTER button to save the setting.
Press Menu button to upgrade the menu.
Auto Automatic mode
Sond Sound activity mode (w/o sound triggering will be black out)
dMH DMX mode
Sound Activity Sensitivity Setting:
Press Menu button to access the menu SEnS
Press UP or DOWN to select the sound sensitivity (range: 0-99)
Press ENTER to save the setting.
Note: If the unit is in Master/Slave or Sound mode without any (music) triggering for 60 seconds, then
the unit will switch to black out mode.
DL-QUAKE250_A5.indd 3
Power
Menu
Up
DMX
Control panel
3
Enter
Down
Sound
2009.9.1 9:33:30 AM