Safety Precautions - König Electronic DL-QUAKE250 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
Problem
A number appears on
display and fixture will
not run a standalone light
show.
An effect fails to reset
correctly.
Lamp cuts out
intermittently or burns out
too quickly.
Fixture does not respond
correctly to music beat in
music trig mode.

Safety precautions:

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
from mains and other equipment if a problem should occur.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
Attention:
This product is marked with this symbol. It means that used electrical and electronic
products should not be mixed with general household waste. There is a separate
collections system for these products.
EINLEITUNG:
Dieser hochentwickelte DMX-steuerbare Multi-Color Lichteffekt-Beleuchtungskörper hat 12
verschiedene rotierende Gobomuster sowie das besondere Feature Gobo-Shaking. Die 250W
Halogenlampe garantiert einen raumfüllenden Effekt. Dieser Lichteffekt ist ideal für permanente
Installation oder mobile Nutzung.
DL-QUAKE250_A5.indd 7
Probable cause
Fixture is set to DMX mode
and is displaying its DMX
address.
The effect may require
mechanical adjustment.
Fixture is too hot.
Music level sensitivity is
incorrectly adjusted.
To reduce risk of electric shock, this product should ONLY be opened by
an authorized technician when service is required. Disconnect the product
DEUTSCH
7
Solution
Use control panel to change fixture
from DMX to standalone auto trig
or music trig.
Contact a qualified technician for
service.
Allow fixture to cool. Check that
there is free airflow around the
fixture. Check and if necessary
clean, fan and grills.
Use control panel to adjust
sensitivity until fixture responds
satisfactorily.
2009.9.1 9:33:30 AM

Publicidad

Tabla de contenido
loading

Tabla de contenido