Cleaning And Sanitizing Procedures - Bras QUARK Serie Manual De Instrucciones

EN GLIS H
Q U A R K
order to reduce the drink outflow (see figure 6).
5. 3 CLEANING AND SANITIZING
PROCEDURES
1
Cleaning and sanitizing of the dispenser are recommended
to guarantee the conservation of the best product taste and the
highest unit efficiency. This section is a procedural guideline
only and is subject to the requirements of the local Health
Authorities.
2
Prior to the disassembly and cleaning, the machine must be
emptied of product. To do this proceed as follows:
- set the power switch to I position
- set mixer/refrigeration switch(es) to I position (Soft Drink
mode)
- place a pail under each faucet and drain all product from
bowls
- set all control switches to the 0 position
5. 3. 1 DISASSEMBLY
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source by unplugging it.
1
Remove cover from the bowl.
2
Remove the bowl by lifting its faucet side up and off the
fastening hooks (see figure 7) and slide it out (see figure 8).
figure 6
figure 7
figure 8
3
Slide the outer spiral out (see 3) and then Outside magnetic
rotor assembly (see figure 10).
4
Remove the bowl gasket from its seat (see figure 11).
5
Dismantle the faucet assembly (see figure 12).
6
Slide the drip tray out and empty it.
14
figure 9
figure 10
figure 11
figure 12