Bras QUARK Serie Manual De Instrucciones página 15

5. 3. 2 CLEANING
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source.
1
Prepare at least two gallons of a mild cleaning solution of
warm (45-60 °C 120-140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong a
solution can cause parts damage, while too mild a solution will
not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastics parts.
2
Using a brush, suitable for the purpose, thoroughly clean all
disassembled parts in the cleaning solution.
ATTENTION
When cleaning the machine, dump it, do not allow exces-
sive amounts of water around the electrically operated
components of the unit. Electrical shock or damage to
the machine may result.
3
In the same manner clean the evaporator cylinder(s) using
a soft bristle brush.
4
Rinse all cleaned parts with cool clean water.
5. 3. 3 SANITIZING
Sanitizing should be performed immediately prior to
starting the machine. Do not allow the unit to sit for
extended periods of time after sanitization.
1
Wash hands with a suitable antibacterial soap.
2
Prepare at least two gallons of a warm (45-60 °C 120-
140 °F) sanitizing solution (100 PPM available chlorine
concentration or 1 spoon of sodium hypoclorite diluted with two
litres of water) according to your local Health Codes and
manufacturer's specifications.
3
Place the parts in the sanitizing solution for five minutes.
4
Place the sanitized parts on a clean dry surface to air dry.
5
Wipe clean all exterior surfaces of the unit. Do not use
abrasive cleaner.
5. 3. 4 ASSEMBLY
1
Slide the drip tray into place.
2
Lubricate faucet piston, outer spiral and outside magnetic
rotor (see points A, B and C of figure 13) only with the grease
supplied by the manufacturer or other food grade approved
lubricant.
3
Assemble the faucet by reversing the disassembly steps
(see figure 12)
4
Fit bowl gasket around its seat.
Note: the largest brim of gasket must face against the rear wall
(see figure 14).
5
Insert the magnetic outside rotor in the evaporator taking
care to accompany it to the end (see figure 15).
6
Install the outer spiral. Slide it over the evaporator until its
hexagonal front notch engages with the hexagonal exposed
end of the magnetic outside rotor (see figure 16).
7
Push the bowl towards the rear wall of the unit until it fits
snugly around the gasket and its front fastening hooks are
15
figure 13
figure 14
figure 15
figure 16