2Nd Level Programming - O&O CSB-BR Manual De Instalacion Y Uso


· :Default
- To reset the default parameters, set parameter  on 1 and exit the menu'.

· :Automation statuses display
- During operation, the control unit displays automation status so the installer is able to follow the logical fl ow of the board.
The statuses are:
The following table gives the 2nd level functions and the single settable parameters.
= DEFAULT value set in factory.
Par Function

Maximum operating time (sec.)

Request for maintenance
Programming maintenance

cycles in thousands
Programming maintenance

cycles in millions

Output 1

Output 2

Output 2
: Idle
: Opening

: Stop opening limit switch
: Stop opening
: Closing

: Stop closing limit switch
: Stop closing
: Not available
: Stop due to photocell triggering

: Opening due to photocell triggering
: Photocell triggering pause
: Stop due to encoder triggering

: Opening due to encoder triggering
: Pause due to encoder triggering
: Maximum working time in opening reached

: Maximum working time in closing reached
6.3 LEVEL PROGRAMMING
2ND
-
: disabled
: active on the confi gured outputs
: active on the confi gured outputs and the bar lights fl ash twice

..
: arm lights command
: request for maintenance
: photocell triggering
 : reverser triggering
: PDM contact actuated
: arm closed
: arm open
: stop contact actuated
: warning fl ash
: Arm locking device
: request for maintenance
: photocell triggering
: reverser triggering
: PDM contact actuated
: arm closed
: arm open
: stop contact actuated
: warning fl ash
: Arm locking device
- 21 -
= parameter value set during installation: must be indicated if
DEFAULT value is modifi ed.
Settable data



.


