Mitsubishi Electric PLK-G Serie Manual Tecnico página 169

CODE
M-296 COPIES ALL PATTERN DATA
M-297 OVERWRITES COMBINATION DATA
M-298 CLEARS COMBINATION FORM
M-299 MILLING CUTTER IS IN LOWER POSITION
M-300 SETTING HAS BEEN CHANGED
M-302 WRITING MODEL AND LANGUAGE SETTING
M-305 INITIALIZES SET VALUE
M-306 USER FOLDER DOES NOT EXIST IN THE USB MEDIUM
M-307 USER FOLDER DOES NOT EXIST IN THE USB MEDIUM
M-309 INITIALIZED SELECTED ITEM
M-312 NO SELECTED ITEM
M-313 RECEIVE TIME OUT OF SERIAL COMMUNICATION
MESSAGE
ARE YOU SURE? Yes: ENTER ICON
*IF THERE IS SAME NUMBER IN THE MEMORY,DATA IS OVERWRITTEN
ARE YOU SURE? Yes: ENTER ICON
ARE YOU SURE? Yes: ENTER ICON
PLEASE RAISE MILL, THEN TOUCH HOME ICON
PLEASE TURN OFF THE POWER. PLEASE RE-TURN ON THE POWER AFTER POWER LED
(GREEN) OF THE CONTROL BOX IS TURNED OFF.
PLEASE INPUT AGAIN
ARE YOU SURE? Yes: ENTER ICON (ALL SETTINGS ARE INITIALIZED)
No: X ICON
USER FOLDER CREATION OK?
PLEASE CREATE USER FOLDER (USER_system)
ARE YOU SURE? Yes: ENTER ICON (SELECTED SETTINGS ARE INITIALIZED)
No: X ICON
INITIALIZATION IS NOT EXECUTED
166
SUB-MESSAGE
No: X ICON
No: X ICON
No: X ICON
Yes: ENTER ICON No: X ICON