Beurer BC 57 Instrucciones De Uso página 31

• Press the START/STOP button
start the blood pressure monitor. All
displays will illuminate briefly.
The blood pressure monitor will begin the
measurement automatically after 5 sec-
onds.
The measurement is taken during the in-
flation phase.
You can cancel the measurement at any time by
pressing the START/STOP button
As soon as a pulse is found, the pulse symbol
played.
• The systolic pressure, diastolic pres-
sure and pulse rate measurements
are displayed.
• E E E E _ appears if the measurement could not be per-
formed properly. Observe the chapter on
error messages/troubleshooting in these
instructions for use and repeat the meas-
urement.
• Now select the desired user memory by pressing the
memory button M. If you do not select a user memory,
to
• Press the START/STOP button
If Bluetooth
ferred after pressing the START/STOP button
The Bluetooth
pressure monitor now attempts to connect to the app for
.
approx. 30 seconds.
is dis-
The Bluetooth
nection is established. All measurement data is automati-
cally transferred to the app. Once the data has been suc-
cessfully transferred, the device switches off.
• If a connection to the app cannot be established after
• If you forget to turn off the device, it will switch off auto-
• Wait for at least 1 minute before taking
31
the measurement is stored in the most recently used
user memory. The relevant symbol M1 or M2 appears
in the display.
blood pressure monitor. The measurement is then
stored in the selected user memory.
® data transfer is activated, data is trans-
® symbol flashes on the display. The blood
®
symbol stops flashing as soon as a con-
30 seconds, the Bluetooth
blood pressure monitor switches off automatically after
3 minutes.
matically after a maximum of 3 minutes. In this case
too, the value is stored in the selected or most recently
used user memory.
another measurement.
to switch off the
.
symbol goes out and the
®