Cleaning And Maintenance; Technical Specifications - Beurer BC 40 Manual De Instrucciones

• you move or speak during the measurement (
on the display)
• the cuff is placed on the arm too tightly or loosely or if the
cuff is damaged (
• the pump pressure is higher than 290 mmHg (
appears on the display)
• the batteries are almost worn out (
In such cases, repeat the measurement. If necessary, rein-
sert or replace the batteries.

8. Cleaning and maintenance

• Clean your blood pressure monitor carefully using a
slightly damp cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances should you hold the unit under
water, as this can cause liquid to enter and damage the unit.
• Never place any heavy objects on the device.

9. Technical specifications

Model no. BC 40
Measurement Oscillometric, non-invasive blood pressure
method measurement on the wrist
Measurement Cuff pressure 0 – 290 mmHg,
range Systolic 50 – 250 mmHg,
Diastolic 40 –180 mmHg,
Pulse 40 – 180 beats/minute
appears on the display)
and ).
appears
Display accu-
racy
Measurement
inaccuracy
Memory
Dimensions
Weight
Cuff size
Permissible
operating con-
ditions
Permissible
storage condi-
tions
Power supply
Battery life
Accessories
Classification
25
Systolic ± 3 mmHg, diastolic ± 3 mmHg, pulse
± 5 % of the value shown
Max. permissible standard deviation accord-
ing to clinical testing: systolic 8 mmHg/dias-
tolic 8 mmHg
60 memory spaces
L 76 mm x W 70 mm x H 23 mm
Approximately 105 g (without batteries)
12.5 to 21.5 cm
+ 10 °C to + 40 °C, ≤ 85 % relative humidity
(non-condensing)
- 20 °C to + 55 °C, ≤ 85 % relative humidity,
800-1060 hPa ambient pressure
2 x 1.5V AAA batteries
For approx. 300 measurements, depending on
levels of blood pressure and pump pressure
Instructions for use, 2 x 1.5V AAA batteries,
storage box
Internal supply, continuous operation, applica-
tion part type BF, IPX0, no AP or APG