Saving And Displaying Measurements; Deleting Stored Values; Error Message/Troubleshooting; Cleaning And Maintenance - Beurer BC 30 Manual De Instrucciones

Blood pressure Systole
value category (in mmHg)
Setting 1:
mild hyperten- 140 – 159 90 – 99
sion
High normal 130 – 139 85 – 89
Normal 120 – 129 80 – 84
Optimal < 120
Source: WHO, 1999 (World Health Organization)

6. Saving and displaying measurements

• The results of every successful measurement are stored
together with the date and time. If there are more than 60
measurements, the oldest measurements are lost.
• Use the button and then the
user memory. Pressing the +/M button displays the average
value of the 3 most recent measurements stored in the user
memory. If you continue to press the memory button +/M,
the most recent individual measured values are displayed in
turn with the date and time.

7. Deleting stored values

To delete individual measurements, you must first select them.
Press and hold the memory button +/M until
display. Then confirm the deletion with the user selection button
( and appear on the display).
Diastole
Action
(in mmHg)
regular monitor-
ing by doctor
regular monitor-
ing by doctor
self-monitoring
< 80 self-monitoring
button to select the desired
appears in the
To delete measurements from a user memory, you must first
select them. Press the memory button +/M and the average
value of the last 3 saved measurements is displayed. Then press
and hold the memory button +/M again until
display. Confirm the deletion with the user selection button
( and appear on the display).

8. Error message/troubleshooting

In the event of errors, the error message _ appears on the
display.
Error messages may appear if:
• it was not possible to record the pulse:
• you move or speak during the measurement:
• the cuff is fastened too tightly or loosely:
• errors occur during the measurement:
• the pump pressure is higher than 300 mmHg:
• the batteries are almost empty
In such cases, repeat the measurement. Ensure that you do not
move or speak. If necessary, reinsert or replace the batteries.

9. Cleaning and maintenance

• Clean the device and cuff carefully using a slightly damp cloth
only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under water,
as this can cause liquid to enter and damage the device and
cuff.
21
appears in the
;
;
;
;
;
.