AKG CK-31 Instrucciones De Uso página 28

4 Installation and Connection
Fig. 2: DPA-P
jumpers and pinout
(factory setting
shown).
Refer to fig. 2.
Table 2: LED Ring
and Bass Cut.
Note:
28
LED A
LED C
MIC +
MIC GND
• At the factory, jumpers have been placed in positions
1, 3, 5, and 7:
- On powering up, the microphone will be muted and
the LED ring will be dark.
- To open the microphone, press the ON/OFF key. The
LED ring will be lit to indicate the microphone is
open.
- To mute the microphone, press the ON/OFF key
again. The LED ring will go out.
Positions 1 and 7 set the following functions:
Position Jumper in place
1 Flat frequency response
7 Mic on/off -> LED on/off
• Positions 1 and 7 will not affect the function of the
ON/OFF key.
DISCREET ACOUSTICS modular
1 2 3 4 5
No jumper
Bass rolloff:
-6 dB below 200 Hz
LED off
6 7