Repair Information - Cooper Greengate ControlKeeper 2 Manual De Instalación

General Information
System LEDs
There are three (3) system status LEDs that are located
in the upper section of the ControlKeeper 2. These status
LEDs will indicate proper operation or potential problems
with the ControlKeeper 2. Normal Operation includes the
following LED states.
Status LED:
The Status LED will flash ON and OFF continuously under
normal operation.
Power LED:
The Power LED is ON when power is applied to the panel.
Network LED:
The Network LED will flash when activity is present on the
network.
Relay Status LEDs
There are two relay status LEDs, one for each of the relays
on the ControlKeeper 2. The relay status LEDs are an
indication of whether the associated relay is energized or
de-energized. If the relay LED is ON, the relay load should
be ON. If the relay LED is OFF , the relay load should be OFF .
RS232 Port
The Lighting Control Software for programming uses the
RS232 phone-jack style communications port with a RJ12
connector. A special cable will be supplied with the
software program for connection to this port. In addition,
other peripheral devices provided by Greengate may plug
into this port for communication purposes.
In ControlKeeper 2 units the RS-232 port may be used for
Digita
Switches. In this configuration only, set the option
®
select DIP Switch 1 to the ON position. With all other
peripheral devices, DIP Switch 1 on the option select switch
should be in the down (OFF) position for proper operation.
Programming the ControlKeeper 2
The ControlKeeper 2 is programmed through the Keeper
Enterprise Software. Please refer to your Keeper Enterprise
Manual for programming details. It is recommended that
a Clear Settings Command be performed on the controller
before the first programming is done to clear any test data
that may be left in the controller from factory testing.

Repair Information

If a repair becomes necessary on your ControlKeeper 2 unit,
please refer all service to Greengate technical support line
at 1-800-553-3879.
6 ControlKeeper® 2
Low Voltage Compartment
Item Reference Drawings
1. DC Ground (Do not connect to Earth or Conduit
Ground)
2. Option Select Switch
3. Switch Input Channels
4. RS232 – RJ12 Connector
5. Network Terminal
6. Network Termination Jumper
7 . Panel ID Selection Switch
8. System Status LEDs
9. Relay 1 Override Switch
10. Relay 1 Status LED
11. High/Low Voltage Barrier
12. Relay Output 1
13. 120V (Black) or 277V (Orange)
14. Neutral (White)
15. Transformer
16. Relay Output 2
17 . Relay 2 Override Switch
18. Relay 2 Status LED
19. Reset Switch
High Voltage Compartment