How It Works; Installation; Carrying Out The Installation - Miele professional XCI-Box-LG Instrucciones De Manejo

en - English

How it works

The XCI box allows external hardware
from Miele and other suppliers to be
connected to the Miele Professional
machine. External hardware includes
payment systems, dispensing systems,
peak load systems, pressure sensors
and external exhaust valves.
These operating and installation instruc-
tions primarily describe how to connect
payment systems. Connections for ex-
ternal hardware other than payment
systems must be made by an author-
ised Miele Service engineer.

Installation

Servicing, modification, testing and
maintenance of electrical appliances
must be carried out in accordance with
all appropriate legal requirements, acci-
dent prevention regulations and valid
standards.
All regulations of the appropriate utility
supply companies and standards relat-
ing to electrical and general safety must
be observed.

Danger of injury due to electric
shock.
Even with the machine switched off,
mains voltage may be applied to
some components.
The Miele Professional machine must
be disconnected from the mains be-
fore performing any maintenance or
repair work.
A machine safety check must be car-
ried out in accordance with national
regulations (e.g. VDE 0701 in Germany).
34
The XCI box must be accessible at all
times to enable service work to be car-
ried out.
Read and observe sections "Current
carrying capacity of the inputs and out-
puts" and "Installing a payment system"
before connecting the additional com-
ponents to the XCI box.

Carrying out the installation

Service and repair work must only be
carried out by a suitably qualified elec-
trician in accordance with all appropri-
ate local and national safety regula-
tions.
 Disconnect the Miele Professional
machine from the mains voltage.
 Attach the XCI box to the wall using
suitable screws.
 Establish the connection between the
XCI box and the Miele Professional
machine and the external hardware
(e.g. payment system).
When connecting external hardware
provided by other manufacturers, the
cable cross-section must not be less
2
than 1.0 mm with a maximum cable
length of 2.50 m.