Putting The Device Into Operation - Clatronic EM 3062 Instrucciones De Servicio

• Remove the motor device and the accessories from the box. Also remove any pa-
ckaging materials that may be present.
• Wipe all the parts with a moist cloth to remove all the dust that may have deposited on
and in the device during transport. Then mount the device again by proceeding in the
opposite order.
Please be particularly careful when handling the knives. There is a danger of injury.
Only hold the blades as near to the ends as possible or by the plastic handling
surfaces.
• Assemble the blades as shown in illustration 1 (ABB 1).
• Insert the ends of the knives into the retainer on the motor device.
• Press the blades in the direction of the motor device until the ends are felt to lock in
place. Check that they are firmly attached.
• Insert the plug in a duly installed 230 V/50 Hz socket.
• Switching on: Please note that for safety reasons the knife can only be switched on if
switches 2 and 3 pressed.
• Do not exert too much pressure when cutting; allow the knife to do the cutting.
• After use, please remove the plug from the socket and take out the blades by pressing
button 1.
WARNING:
GB
• Remove the mains plug from the socket.
• The cutting blades are extremely sharp!
• Under no circumstances should you place the device in water for cleaning. Otherwise
this might result in an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Housing
• Wipe off the housing with a damp cloth and dry with a dry cloth.
36
-EM3062_Rewe.indd 36

Putting the device into operation

WARNING:
Cleaning
15.09.2009 9:10:48 Uh