Changing The Input Attenuation Setting - Sony WRT-807B Manual De Instrucciones

Setting

Changing the Input Attenuation Setting

The input attenuation setting can be changed within a range
of 0 dB to 21 dB (in 3-dB steps) in either Setting mode or
Transmit mode.
Changing the input attenuation in Setting
mode
1
Set the microphone to Setting mode.
2
If the attenuation level is not displayed, press the SET
button until it appears.
3
Press the + or – button to change the attenuation setting.
AF RF BATT
Hold down the button to change the level quickly.
4
Once the desired level appears, turn the POWER switch
to OFF to release Setting mode, or press the SET button
to continue operations in Setting mode.
10
(GB)
+ button AF RF BATT
– button
The next time you turn on the microphone (by turning the
POWER switch to ON), the microphone enter Transmit
mode with the selected attenuation setting.
Changing the input attenuation in Transmit
mode
You can also change the input attenuation setting while
transmitting in Transmit mode.
1
If the attenuation level is not displayed, press the SET
button until it appears.
2
Press the + or – button to change the attenuation setting.