Notes On Use; Use; Cleaning - Profi Cook PC-WKS 1148 T Manual De Instrucciones

Notes on Use

Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives
or ingredients.
Mains Lead
Completely unwind the length of mains lead that you require
from the bottom section of the base. Please ensure that the
mains lead does not become tangled up.
Electrical Connection
Check whether the electrical voltage that you intend to use is
the same as that of the appliance. Details are to be found on
the label on the base.
Connected Wattage
The total power consumption of this appliance can be up to
1630 W.
CAUTION: Overload!
Do not use any multiple sockets, as this appliance is too
powerful.
Switching On / Off
• Switching on:
Press the toggle switch downwards. The indicator light in
the switch lights up.
• Switching off:
Press the toggle switch upwards. The indicator light in the
switch goes off.

Use

NOTE:
Always use fresh water.
1. Place the appliance on a flat surface.
2. Open the lid by turning it counter-clockwise. Take off the
lid.
WARNING:
• Always turn the appliance off before cleaning it and remove the
mains plug. Wait until the appliance has cooled down.
• Never immerse the appliance or the base into water or other
liquids. Otherwise this might result in an electric shock or fire.
36
PC-WKS1148T_IM_new
3. Fill in the water (max. 1.5 litre). You can read the filling
level on the water level indicator of the kettle.
4. Close the lid. Screw the lid onto the flask so that the
button on the lid points to the handle.
5. Place the kettle flush on the base.
6. Only connect the appliance to a properly installed safety
socket.
7. Switch on the kettle by pressing the switch.
The control lamp in the switch will light up.
NOTE:
During cooking, condensation water can accumulate on the
base. This is normal and not a malfunction of the appliance.
Pausing / Terminating Operation
There are two options to interrupt the boiling process or to
terminate it:
1. The appliance will shut off automatically after the boiling
process. The indicator lamp will go out.
2. Push the switch upwards to finish operation.
CAUTION:
Do not remove the appliance from the base without shutting
it off first
The contacts on the base are not suitable for disconnecting
the power supply.
WARNING: Danger of Scalding!
When pouring the water out, keep the lid closed.
• Disconnect the power cord.
• Emptying the water container. To pour out water, press
down the button on the lid.
Keeping Warm
Your water boiler has a thermo function. It can keep water
warm for up to 4 hours.
Mains Cable Take-Up Appliance
The mains cable can be wound up on the base.

Cleaning

13.09.17