Recommended Recipes - BOMANN KM 399 CB Instrucciones De Servicio

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

If you have used the mixer, cover the motor shaft of the mixer

motor with the safety cover:

1. Opening the swivel arm: Press the lever (4). Manually

guide the swivel arm to the top position.

2. If you need the splash guard, attach it now to the swivel

arm from below. Hold the splash guard (8) in such a

way that the fill opening is positioned in front of you. On

the bottom of the swivel arm, there are two recesses on

the front and back. Insert the splash guard with its guide

lugs into these recesses. Turn the splash guard towards

LOCK to lock it.

3. If you want to use the dough hook (12) or mixing hook

(10), first attach the hook splash guard (11). It will

prevent the drive shaft from getting in contact with the

dough.

Hold the guard like a bowl. Insert the dough hook or the

mixing hook from below through the recess of the guard

and then lock it by turning it one quarter of a turn.

Table Dough Types and Tools

Dough Type

Heavy dough (e.g. bread or shortcrust)

Medium dough (e.g. cake batter)

Light dough (e.g. waffle or crêpes dough,

pudding)

Cream

Egg whites

NOTE:

• Short time operation: With heavy dough do not oper-

ate the appliance longer than 5 minutes and leave for 10

minutes to cool down.

• Setting P for pulse operation: Briefly activate the

highest motor setting by holding the control knob in this

position.

Pulse Operation

WARNING: Risk of injury!

• Always set the control knob to "0" if you want to interrupt

operation.

• Disconnect the plug from the mains if you want to

change the attachment.

• Wait for the attachment to come to a complete stop!

• If you activate the lever (4) during operation to raise the

arm, a safety switch deactivates the motor.

• The motor switches on again as soon as you lower the

swivel arm again!

KM399CB_IM

4. Attaching accessories:

On the top end of the accesso-

ries, there is a recess for the

drive shaft and the splint. Slide

the accessory over the drive

shaft. Push down and at the

same time turn the accessory

anticlockwise in order for the

splint of the drive shaft to lock into the accessory.

5. Mixing bowl: Place the mixing bowl into its holder. Turn

the bowl towards

6. Fill your ingredients into the mixing bowl.

7. Check whether the control knob is set to "0".

8. Press the lever (4) to lower the arm. You must press onto

the arm from above, until it locks into the lowest position.

9. Connect the mains plug to a tested plug socket.

10. Select the speed using the table below.

Tool

Setting

Dough hook

1 - 3

max. 2.5 kg

Mixing hook

3 - 4

max. 3.0 kg

Egg beater

4 - 5

max. 3.5 liters

min. 200 ml

Egg beater

max. 2 liters

Egg beater

3 -10 egg whites

End Operation and Remove Bowl

• Set the control knob to "0" after use. Disconnect the plug

from the mains.

• Press the lever (4) down for the arm to lift.

• Remove the tool.

• Turn the mixing bowl briefly anticlockwise to remove it.

• Loosen the dough with a spatula and remove it from the

mixing bowl.

• Clean all used components as described in chapter

"Cleaning".