Interrupting The Cleaning Process; Cleaning Small Objects; Cleaning Watches; Cleaning Larger Objects - AEG USR 5516 Manual De Instrucciones

Clatronic-GB.book Seite 13 Donnerstag, 14. August 2008 10:23 10
1. Open the lid.
2. Fill the water tank with cold water. Fill the water
tank up to the "MAX" indicator. Remove the basket
insert. The "MAX" mark is located on the side.
NOTE:
Add a common cleaning solution to the water tank to
increase the cleaning effect.
3. Connect the device to an electrical outlet.
4. Place the object to be cleaned into the water tank.
You can also place the object into the basket or
attach it to the watch holder. Hang items such as
chains, bracelets or similar objects across the
retaining bracket of the basket.
5. Close the lid. Leave the lid open for larger items.
6. Press the ON/OFF key.
The device now begins with the cleaning.
- The operating indicator lights during the
cleaning process.
- The cleaning process is ended automatically
after 180 seconds. The operating indicator
goes off.
7. Open the lid and remove the cleaned object.
8. Pull the plug from the electrical outlet.
9. Empty the water tank.

Interrupting the cleaning process

The cleaning process normally lasts 180 seconds.
Press the "On/Off" key to interrupt the cleaning
process before this time has lapsed.
CAUTION:
Change the water no later than after the third
cleaning process. Fill the tank with cold water to
avoid overheating.

Cleaning small objects

Small objects can begin to move around in the tank
during the cleaning process. This can possibly damage
them, e.g. through scratches.
Therefore use the following approach with small
objects:
1. Put small objects in the basket insert included with
the device.
2. Place the basket insert into the device.
3. Perform the cleaning process
"Cleaning objects".

Cleaning watches

NOTE:
The use of the basket insert reduces the cleaning
output by approx. 30%.
You can also use the device to clean watches.
CAUTION:
The cleaning process can cause water to enter the
watch and damage it. Only clean waterproof watches
certified for a depth of at least 30 meters. Watches
often loose their watertightness with age. You may
therefore want to have your watch checked by a
watchmaker for its watertightness.
1. Attach the watch to the watch holder.
2. Place the watch holder into the device (Fig. 2).
3. Perform the cleaning process
"Cleaning objects".
NOTE:
The use of the watch holder reduces the cleaning
output by approx. 30%.

Cleaning larger objects

You can also use the device to clean larger objects.
1. Immerse the object to be cleaned only partially into
the water tank.
2. Perform the cleaning process
"Cleaning objects".

Cleaning CDs/DVDs

1. Remove the basket.
2. Place the CD/DVD into the holder as shown in
(Fig. 3).
3. Place the CD/DVD holder into the centre of the
water tank.
CAUTION:
Make sure the spacer ring is between the CDs if you
want to clean two CDs/DVDs. The CDs/DVDs may
become damaged when they lie on top of each
other.
Page 12,
Cleaning
Page 12,
Page 12,
13