Skil 7305 Instrucciones De Funcionamiento Y Seguridad página 16

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SM 1619X04464 05-09:SM 1619X04464 05-09 5/20/09 1:54 PM Page 16
and remove it from the work before switching
the tool off. Operating your sander in this
manner will prolong switch and motor life, and
greatly increase the quality of your work.
Move the sander in long steady strokes parallel
to the grain using some lateral motion to
overlap the strokes by as much as 75%. DO
NOT apply excessive pressure — let the tool
do the work but always make sure the pad is
parallel to the work surface. Excessive
pressure will result in poor handling, vibration,
and unwanted sanding marks (Fig. 17).
Use the tool with its standard backing pad for
large work surfaces, corners and edges
(Fig. 18).
Use the tool with special sanding attachments
for hard to reach areas (Fig. 19).
If the surface is rough, begin with coarser grits
and then complete the surfacing with medium
and fine abrasives. To avoid uneven results, do
not skip more than one grit size when going
from coarser to finer, and do not sand in one
area for too long. When the job is completed,
gently lift the tool from the work surface and
slide switch to the "OFF" position.
POLISHING: Your Multi-finishing sander may
be fitted with optional abrasive mesh or
polishing pads to polish or remove scratches or
corrosion from metal, painted, or other
surfaces. The tool is operated in much the
same way as when sanding, but the following
FIG. 17
points should be observed;
Use light pressure and a circular or overlapping
motion to remove scratches and corrosion or
polish a surface. If using a compound, use only
as much as necessary and do not use the dust
extraction feature.
When working in very confined areas or
louvered panels, the pad extension plate
should be used.
Clean the buffing or mesh pads with mild deter-
gents and warm water. DO NOT use solvents.
Application Advice
The flexible sanding attachment is intended for
rounding edged surfaces (Fig. 20a).
The flexible sanding can also be used on all
rounded surfaces with a maximum diameter of
10 cm (Fig. 20b).
FIG. 18
-16-

Publicidad

Tabla de contenido
loading

Tabla de contenido