Tabla de contenido
Publicidad
AVOID GASEOUS AREAS
Do not operate electric tools in gaseous or explosive atmo-
spheres. Motors in these tools normally spark, and may re-
sult in a dangerous condition.
MAINTAIN TOOLS WITH CARE
Keep tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories.
Inspect tool cords periodically and if damaged, have repaired
by authorized service facility. Inspect extension cords
periodically and replace if damaged. Keep handles dry, clean
and free from oil and grease.
Some dust created by power sanding,
W RNING
sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry
products, and
• Arsenic and chromium from chemically treated lumber.
Specific Safety Instructions for X-bench
Read and understand all instructions for use of X-
bench. Failure to follow all instructions listed below may
result in serious personal injury.
The stamped rails or clamps may have sharp edges.
Be careful in handling the bench to prevent being cut.
Fully assemble and tighten all the fasteners required
for this stand. Also remember to occasionally check the
stand and make sure it is still tight. A loose stand is
unstable and may shift in use and cause serious injury.
before operating make sure the entire unit is placed
on a solid, flat, level surface. Serious injury could occur
if tool is unstable and tips.
Never stand on table or use as ladder or scaffolding.
Serious injury could occur if the table is tipped or the
cutting tool is accidentally contacted. Do not store
materials on or near the table such that it is necessary to
stand on the table to reach them.
The expected time to assemble and properly adjust this saw is two hours.
Your risk from these exposures varies, depending on how often
you do this type of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
W RNING
Place the working stand on a solid, flat and level
surface. When the working stand can shift or rock, the
power tool or work piece cannot be steadily and safely
controlled.
Do not overload the working stand or use as ladder or
scaffolding. Overloading or standing on the working stand
cause the stand to be "top-heavy" and likely to tip over.
Use only Skil replacement parts. Any others may create a
hazard.
Do not load with more than 220 lbs. This table when
fully set and clamps are tightened is maximum rated to
220 lbs. Table could collapse under additional loads.
Do not use as storage shelf. This table is not intended
to be a storage shelf.
Do not store X-bench in damp locations. Use only in
dry locations. Humidity will cause the table top to distort
or the locks to become loose.
Use only Skil replacement parts. Any others may create
a hazard.
Don't use with work pieces that cannot be properly
secured to the X-bench.
Insure wood/workpiece is properly positioned before
cutting. Incorrectly positioned workpiece may cause you to
inadvertently cut into the X-Bench top, clamps or frame.
Assembly Time
3
This product contains a chemical known to the
State of California to cause cancer.
Publicidad
Tabla de contenido
