Tabla de contenido
Publicidad
Step 1. Install clamping blocks into the holes in the workbench
(Fig. 6).
Fig. 6
Step 2. Turn both clamping handles counter-clockwise until they stop,
then push clamping jaw back as far as it will go (Fig. 7).
Fig. 7
A
Step 3. For additional workpiece support, fold out the clamping
arms (Fig. 8).
Fig. 8
C
Operating Instructions
b
A
A
C
Step 4. Hold the workpiece with one hand between the jaws and
lay it down on the clamping arms (Fig. 9).
Fig. 9
Step 5. Pull adjustable clamping jaw with the other hand toward
the workpiece and fixed clamping jaw (Fig. 10).
Fig. 10
E
Step 6. Tighten both clamping handles 1/2 turn clockwise to lock
into place. To release, turn handles 1/2 turn counter-clockwise
(Fig. 11).
Fig. 11
A
9
b
A
Publicidad
Tabla de contenido
