Battery Charging; Wall Mount - Beper 50.910 Manual De Instrucciones

Rechargeable vacuum cleaner Use instructions

BATTERY CHARGING

Warning: Do not use any chargers other than the one supplied. All repairs or battery replacement
should be performed by an authorized technical service. When charging, the charger heats up
slightly. This is normal, unless it heats up excessively. Before the first use, it is advisable to charge
the batteries completely. This charge will take 5 hours.
1. Set the on/off switch (3) to "O" position. And make sure it is in the off position before unplugging
the charger cable when charging is finished.
2. Place the vacuum cleaner in a stable position. To do this: Slot the catch located on the joint betwe-
en the main body (1) and the suction head (20) into its housing and insert the rear of the handgrip
into the wall mount (26), the vacuum cleaner will remain upright.
3. Plug the charger (25) into the charge connector (8).
4. Plug the charger into the mains socket. The LED indicator (2) will light up in red while it is char-
ging. When the charge is between 80 to 100% it will flash green and switch off automatically when
the charge is completed.
5. After charging, unplug the charger from the wall socket and the unit. Store it in a safe place for
future charges. The unit is now ready for use.
Recommendations to prolong battery life
Do not leave the charger connected for extended periods of time. Unplug it after charging.
LITHIUM-ION batteries do not have the memory effect. After each use, charge the vacuum cleaner
for maximum battery usage time.
Do not store or charge the appliance near radiators or other sources of heat, or exposed to direct
sunlight.
Do not charge the appliance in dirty or wet places. The room temperature should be between 0 ºC
and 37 ºC.

WALL MOUNT

Drill two holes with a distance of 103 mm on the wall and insert the dowels. Attach the wall mount
onto the dowels. Then insert the washer and the long screw to have the wall mount fixed firmly.
16