Standard Accessories - Hitachi CE 18DSL Instrucciones De Manejo

English
Power Output
2 to 3 digit number
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
CE18DSL : Cordless Shear
Read all safety warnings and all instructions.
Always wear eye protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/
EC on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
SPECIFICATIONS
Voltage
Mild steel plate (400 N/mm²)
Cutting capacity Stainless steel plate (600 N/mm²)
Aluminum plate (200 N/mm²)
Number of strokes at no load
Wieght*
* According to EPTA-Procedure 01/2003
NOTE
Due to HITACHI's continuing program of research and development, the specifi cations herein are subject to change
without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect to the power source. (Fig. 2)
When charging the battery from an AC power source
○ Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
Wh
V Rated voltage
min Revolution or reciprocations per minute
-1
Switching ON
Switching OFF
Warning
Disconnect the battery
Battery capacity
Remaining battery indicator switch
The battery remaining power is nearly empty.
Recharge the battery soonest possible
The battery remaining power is a half.
The battery remaining power is enough.

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 162.
Standard accessories are subject to change without notice.
APPLICATIONS
For shearing steel plate, brass plate, copper plate, aluminum
plate, stainless steel plate, tin plate, and other metal plates,
also leather and fi berboard.
5300 min
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
When charging the battery from a DC 12V in-car power
source (UC18YML2)
○ Secure the battery charger in place in the car.
Use the strap supplied with the battery charger to fasten
the battery charger in place and prevent it from moving
inadvertently. (See Fig. 9)
4
18 V
1.6 mm
1.2 mm
2.3 mm
(14.4 V : 5000 min )
-1 -1
2.2 kg