Peg-Perego Pliko P3 Pramette Instrucciones De Uso página 17

ADJUSTING THE FOOTBOARD
20• The footboard can be adjusted to
three different positions. To lower the
footboard, pull the two small levers
downward while lowering. To lift the
footboard, pull it up until it clicks into
place. This is the third, highest position
(see figure) for the baby carriage version
of Pliko P3-Pramette.
ADJUSTING THE BACKREST
21• The backrest can be reclined in four
positions. To lower the backrest, raise
the handle as you lower the backrest,
blocking it in the desired position. To
raise it, push the backrest upward.
SWIVELLING WHEELS
22• To make the front wheels swivel, push
down as shown in the figure. To fix the
wheels, pull up the lever.
ADJUSTING THE HANDLES
23• The height of the handles can be adjusted
in two positions. For the upper position,
press the button as you raise the handle.
To lower it, press the button as you lower
the handle.
REAR LEDGE
24• The rear ledge helps overcome small rises
and can also be used to carry a second
child.
LOADING SEQUENCE
25• To use the stroller with two children,
brake the stroller, place the smaller child
in the seat and fasten the safety belt (1).
Grip the handles (2) and help the second
child climb onto the footrest (3). Never
leave your children unattended. Do not
allow the child to climb onto the rear
footrest when the stroller is empty.
STROLLER-BABY CARRIAGE
26• Pliko P3-Pramette is the new stroller with
a baby carriage incorporated. With a flick
of your hand, you can turn the stroller
into a baby carriage, and back again.
• The hood, thanks to its reversible
attachment system, can also be installed
on the part by the handles when in the
stroller version (A) or on the part opposite
the handles when in the carriage version
(B). Before removing the hood to turn it
around, close it and bring it right forward
to rotate the fasteners, then detach it and
reinstall it on the opposite part; you can
even rotate the fasteners with your hands.
• The hood comes with a zipper, to make
it easy to attach products from our
accessory line, such as the rain canopy
and the mosquito netting.
• The Pliko P3-Pramette cover can be
mounted on the same side as the
footboard for the stroller version (A), and
on the same side as the backrest for the
baby carriage version (B).
VERSION "A" - STROLLER (PLIKO P3)
27• To mount the hood on the stroller, place
it on the same side as the handles and
push the tabs downwards, as shown in
the figure. (Turn the hood attachment to
adjust it for mounting the hood on the
stroller).
28• To extend the hood, push the brace
downwards. The hood can be reclined
along with the backrest.
29• To mount the cover, zip it onto the
footboard as shown in the figure.
REMOVING THE HOOD
30• To remove the hood, you must unbutton
it from the stroller, loosen the couplings
and raise the tabs of the fasteners,
pushing towards the inside of the stroller.
VERSION "B" - BABY CARRIAGE
(PRAMETTE)
31• To turn the stroller into a baby carriage,
remove the hood and the cover if they
have been mounted. Lift the footboard to
its highest position. Place the front bar in
the second position, and make sure the
safety belts are attached to the backrest
by inserting the tab through the special
holder in the sack.
32• Unbutton the tab buttons, as indicated
in the figure from the backrest sack and
lower as indicated in figure.
33• Unzip the two zippers found on the top of
the backrest and fold the sack as indicated
in the figure.
34• Unite the sack zipper and the footboard
zipper, encompassing the front bar and
arrange the sack as indicated in the
figure.
35• Lower the backrest completely, and
lift the tab as shown in the figure. The
bassinet part of the baby carriage is now
ready.
36• Mount the hood on the opposite side
from the handles, by pushing the tabs
downward as shown in the figure. (Turn
the hood attachment to adjust it for
mounting the hood on the stroller)
37• and button it under the footboard, as
indicated in the figure.
38• Attach the hood to the backrest and
button it at the sides, as shown in the
figure.
RAIN CANOPY
39• To mount the rain canopy, zip it onto the
hood.
40• The figure shows the rain canopy on the
stroller version of Pramette.
41• The figure shows where to fasten the rain
canopy button and elastic band on the
Pramette stroller version.
42• The figure shows the lowered rain canopy