Preselecting The Speed - MIRKA PS 1437 Instrucciones De Funcionamiento

Polisher PS 1437
Switching on and off
Brief operation without engaged switch
rocker:
 Press and hold down the switch.
 To switch off, release the switch.
Continuous operation with engaged
switch rocker:
 Press and hold down the switch.
 To lock into position, hold down the
locking button and release the switch.
 To switch off, briefly press and release
the switch.
NOTE!
Following a power failure, the switched on
power tool does not restart.

Preselecting the speed

 To set the operating speed, move the dial
(10) to the required value.
 Gently press the switch (8) to accelerate
the power tool up to the preselected
speed.
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
NOTE!
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.
Attaching the tool holder
 Pull out the mains plug.
 Press and hold down the spindle lock
(1.).
 Screw the tool holder (Velcro pad,
backed fleece, sanding pad) clockwise
onto the spindle and tighten hand-tight
(2.).
63