Corghi CompactLine EM 9250 Manual De Uso página 89

Centre of the notch in the weight holder
With the version with automatic sensor, proceed as follows:
- Move the end of the automatic measuring arm in line with the plane selected for the
application of the inner weight. In Alu 1P the centre of the notch in the holder is used
as the reference for the centre line of the weight (fig.14). In Alu 2P refer to the rim edge,
since the inner weight is of the clip type (Fig.15).
- Keep the arm in position. After two seconds the machine emits an acoustic confirmation
signal to indicate that the distance and diameter values have been acquired.
- Move the end of the automatic measuring arm in correspondence with the plane selected
for the application of the outer weight (Fig. 14a/15a), in the same manner as described
previously for the inner side.
Pay maximum attention when the end of the arm is being placed in an area of the
rim free of discontinuity, so that the weight can be applied in that position.
- Keep the arm in position. After two seconds the machine emits an acoustic confirmation
signal to indicate that the distance and diameter values have been acquired.
- Return the measuring arm to the rest position. Automatically the machine will setup in
the ALUP balancing programmes (FSP programme).
- Carry out a spin.
- At the end of the spin, if you want to change the balancing programme set automatically
by the machine (FSP), select the
selected.
IN THE VERSION WITH MANUAL SENSOR, PROCEED AS FOLLOWS:
- Press the key to prepare the machine for entering distance d1 relative to the
internal side (the distance LED lights up on the panel).
- Bring the end of the measuring arm level with the plane selected for applying the in-
ternal weight (Fig. 14 for ALU 1P, Fig. 15 for ALU 2P). In Alu 1P the centre of the notch in
the holder is used as the reference for the centre line of the weight. In Alu 2 P, the rim
edge is taken as a reference, since the inner weight is of the conventional clip type.
Pay maximum attention when the end of the arm is being placed in an area of the
rim free of discontinuity, so that the weight can be applied in that position.
EM 9250 CompactLine Operator's manual
Centre of the notch in the holder without the
weight holder
or key until the required programme is
UK
89