LG TROMM DLE5955W Instrucciones De Instalación página 15

INSTALLATIONINSTRUCTIONS
VENTING THE DRYER (cont.)
Ductwork
0 65 ft. (19.8 m) 45 ft. (13.7 m)
Recommended 1 55 ft. (16.8 m) 35 ft. (10.7 m)
2 47 ft. (13.7 m) 30 ft. (9.1 m)
3 36 ft. (11.0 m) 25 ft. (7.6 m)
/_02o,nl /_02oml 4 28 ft. (8.5 m) 20 ft. (6.1 m)
Use Only for Short 0 55 ft. (16.8 m) 35 ft. (10.7 m)
Run Installations 1 47 ft. (13.7 m) 27 ft. (8.1 m)
2 41 ft. (12.5 m) 21 ft. (6.4 m)
3 30ft. (9.1 m) 17ft. (5.2 m)
/........, 4 22 ft. (6.7 m) _../
NOTE: Deduct 6 ft. (1.8 m) for each additional elbow. It is not recommended to use more than four 90 ° elbows.
Routing and Connecting Ductwork
Follow the guidelines below to maximize drying
performance and reduce lint buildup and
condensation in the ductwork.
NOTE: Ductwork and fittings are NOT included
and must be purchased separately.
• Use 4-in. (10 cm) diameter rigid or semirigid
metal ductwork.
• The exhaust duct run should be as short as
possible.
• Use as few elbow joints as possible.
The male end of each section of exhaust duct
must
point
away from the
dryer.
Use duct
tape
on all duct
joints.
Insulate ductwork that runs
through
unheated
areas in order to reduce condensation and lint
buildup
on duct surfaces.
iMPORTANT: Failure to exhaust the
dryer
correctly
will void the
dryer's warranty.
Correct Venting
incorrect Venting
15