LaserLiner X3-Laser Manual De Instrucciones página 17

3
Horizontal and vertical levelling
Release the transport restraint, set slide switch (2) to „ON". The horizontal
laser line appears. The laser lines can be switched individually with the
selection button.
LASER
The transport restraint must be released for horizontal and vertical
!
levelling. The laser lines flash when the device is outside the automatic
levelling range of 3°. Position the device such that it is within the
levelling range.
4
Slope mode
Do not release the transport restraint, set slide switch (2) to „OFF".
Select the laser with the selector button (9). Sloping planes and tilts
can now be measured. In this mode, the laser lines no longer align
automatically. This is signalised by the laser lines flashing.
LASER
LASER LASER
LASER LASER
X3-Laser
LASER
LASER LASER
17
EN