Care And Maintenance; Accessories - Rothenberger RODIADRILL 500 Instrucciones De Uso

Removal of the drilling core on through borings
Please take precautions to prevent physical injuries or property damage.
 Allow the drilling core to fall out of the bit.
If the core should jam in the bit, use a rod to push it out from the rear.
Avoid damage to the ground.
On no account use a hammer or spanner to hit the outside of the drill bit in order
to release the core. This could deform the pipe and it would then definitely no
longer be possible to remove the drilling core from the bit.
Removal of the drilling core from tapped blind holes
 Use a screwdriver, chisel or similar tools to penetrate the annular gap that has emerged and
break and remove the core by means of a brief, forceful lateral jerk or hammer blow.
The deeper the borehole, the easier it is to break the cores. Thus, optimal results are achieved if
the borehole depth is at least the same as the diameter of the drill bit.
5

Care and Maintenance

In order to avoid damage to the equipment and guarantee trouble-free work, all parts must be
cleaned and lubricated regularly.
Rub off the equipment after every drilling job and blow out using compressed air.
If it is foreseeable that the equipment will not be used for a longer period of time, remove the drill
bit from the motor. If this is not observed, the drill bit and motor shaft can be corroded together in
unfavourable circumstances. It would be very difficult to separate both parts, causing damage.
The following work should be carried out on a weekly basis at least. Carry out on an appropriate-
ly more frequent basis in the case of more intensive work.
– Check and replace carbon brushes if necessary approximately every 250 operating
– use a fine brush to clean the collector cavity.
Important! All maintenance, overhauling and repair work must only be carried out by trained
specialised staff.
6

Accessories

Accessory Name
Extraction Rotor 1.1/4" UNC
Extraction Rotor M 30 x 2
Copper Ring 1.1/4"
RODIA DRY CLEANER 1200
RODIA CLEANER 1400
Pressurized water container
Submersible water pump RODIAPUMP
Drill bits
Extensions G 1/2":
Nominal length 100 mm
Nominal length 200 mm
Nominal length 300 mm
Nominal length 500 mm
16
ROTHENBERGER Part Number
FF40056
FF40057
FF35190
FF35148
FF35210
FF35026
FF35029
www.rothenberger.com
FF35040
FF35045
FF35050
FF35055
ENGLISH