Compatible Products - DeWalt DWX723 Manual De Instrucciones

Locking Locator Clip (Fig. 1)
The locking locator clip (I) keeps the saw from sliding left or right
during cutting operations. To move the clip, remove saw/bracket
assembly, loosen the screw in the center of the clip, slide it to the
desired position and tighten the screw. You can then remount the
saw/bracket in the new location.
Removing the Saw
Once the miter saw is fastened to the brackets, it can be removed
by grasping the release levers, pulling up slightly to clear the beam
and can be set down on the non marring feet for transportation or
cleaning.
Carry Handle (Fig. 10)
A handle has been supplied to transport the
miter saw stand to and from the work site.
WARNING: To reduce the risk of personal
injury, DO NOT attempt to store or carry the
stand with the saw attached. Loss of control
may result.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, do not create unstable conditions and use only with D
miter saw stands.

COMPATIBLE PRODUCTS

DW7231 – Miter saw mounting brackets
DW7232 – Work piece support and length stops
DW7029 – Wide work piece support and length stops
DW7027 – Roller work piece support
DW7028 – Extension support
DW7026 – Carry strap
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286,
call 1-800-4-D
dewalt.com.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments should be performed by a D
center, a D
FIG. 10
service personnel. Always use identical replacement parts.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty
E
materials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair
information, visit www.dewalt.com or call 1-800-4-D
433-9258). This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by others. This
warranty gives you specific legal rights and you may have other
WALT
E rights which vary in certain states or provinces.
In addition to the warranty, D
D WALT will maintain the tool and replace worn parts caused by
E
normal use, for free, any time during the first year after purchase.
6
WALT (1-800-433-9258) or visit our website www.
E
WALT authorized service center or other qualified
E
WALT tools are covered by our:
E
1 YEAR FREE SERVICE
WALT
E
WALT factory service
E
WALT (1-800-
E