Troy-Bilt 020241 Manual Del Propietário página 10

Section 4: Opecat[on
9. Engage trigger Hock[o spray gun trigger (Figure HO).
HO. Sgar[ engine according [o instructions given in engine
owner's manuaLAHso see operating instructions gag
located on the pressure washer.
WANNING
When starring engine, pull cord slowly until resistance is fek
and then pull rapidly to avoid kickback.
Hfengine s_arts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun_
NOTE: Always keep the throttHe lever in the "Fast"
_osition when operating the pressure washer.
WANNING
How to $topYour Pressure Washer
[. Le[ engine idle for _:wo minutes.
2. Turn engine off according [o ins[ruc[ions given in
engine owner's manual
3. Squeeze trigger on spray gun to relieve trapped
pressure in hose to avoid iniuryo
NOTE: A smaHHamount of wafer wiHHsquirt out when
pressure is released.
WARNING;
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
Squeeze trigger on spray gun to relieve trapped pressure,
every time you stop engine. Engage trigger lock on spray gun:
4. Engage trigger loci< on spray gun when not in use.
DO NOT touch hot surfaces.
Allow equipment to cool before touching
The pressure washer must be at least 5 feet from structures
having combustible wails and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for" adequate cooling, maintenance and servicing.
Hnthe State of California a spark arrester is required by law
(Section ,I,142 of the California PuNic Resources Code). Other
states may have similar laws. Federal laws apply on federal
lands. Hfyou equip the muffler with a spark arrester, it must be
maintained in effective working order: