Troy-Bilt 020241 Manual Del Propietário página 7

Section 3: Assembly
2. Insert carriage bok through Heft side hoHe from outside
of unit and attach a phstic knob from inside of unit
(viewing from rear of unit).Tighten by hand (Figure 2).
3. Insert %" bok through hoHe on right side of handHe
(viewing from rear of unit) and attach phstic knob.
Tighten knob by hand (Figure 2).
4. Insert"L" bolt through hole iust above billboard on
right side of handle (viewing from rear of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 2).Tighten by hand.
Place accessory tray over holes on handle (viewing
from front of unit). Push the tree clips into the holes
until they sit fiat against the accessory tray (Figure 3).
* Refer to engine manual for oil and fuel fill information,
, Damage to equipment resulting from failure to follow this
instruction will void warrant);
° Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
O